HESLY Aluminum Bar Grating is lightweight, corrosion resistant,
non-sparking and has an unmatched strength-to-weight ratio.
Manufactured from ASTM B221, 6063 or 6061 alloy, aluminum grating
is available in four distinct products, type "SG" Swaged Rectangular Bar, type "SGI" Swaged "I" Bar, type "SGF" Swaged Flush-Top and type "ADT" Dovetail Pressure Locked. All four products are available with
bearing bar spacing ranging from 19/16" (1-3/16") to 7/16" on
center and with cross bars at either 4" or 2" on center.
Rectangular bar products are manufactured with standard plain or
optional serrated walking surfaces and "I" bar products are manufactured with a standard skid-resistant
striated walking surface. Aluminum products are typically shipped
“mill finish” with no additional treatment. For architectural
applications or highly corrosive environments, supplemental
anodizing, chemical cleaning or powder coat finishes are available.
The following Aluminum Load Tables provide detailed specification
information relating to all four aluminum products.
Type "SG" Swaged Rectangular Aluminum Grating
The most widely used aluminum grating, type "SG" rectangular bar provides clean, crisp lines and the cross bar is
fully locked within the bearing bar, slightly below the top
surface. Type 19-SG-4 aluminum grating is the industry recognized
standard for industrial applications with nearly 80% open area.
Type "SG" gratings are available in close mesh ADA conforming spacings
11-SG-4 and 7-SG-4 which are commonly used in public areas. When
specifying type 11-SG-4 for ADA applications, 3/16" thick bearing
bars must be specified.
Type "SGI" Swaged"I-Bar" Aluminum Grating
Manufactured with highly efficient "I" shaped extruded bearing bars, type "SGI" aluminum grating carries the same load as 3/16” thick rectangular
bar type "SG" aluminum grating, but weighs slightly less per square foot.
Additionally, the striated top and bottom flanges of the "I" bar provide enhanced skid resistance without the cost of
Type"SGF" Swaged Flush-Top Aluminum Grating
Manufactured with a unique, extruded cross bar that is flush with
the top surface of the bearing bars after swaging, type "SGF" aluminum grating provides an enhanced walking surface for areas
subject to continuous pedestrian traffic. Available in rectangular
bar with plain or serrated surfaces, type "SGF" aluminum grating is also available in ADA conforming spacings for
applications located in the public way.
Type "ADT" Aluminum Dovetail Pressure Locked Grating
Type "ADT" aluminum gratings have deep rectangular cross bars and are
manufactured by inserting pre-punched bearing bars and cross bars
into an “eggcrate” configuration and deforming the cross bars under
intense hydraulic pressure. The deep cross bars on type "ADT" gratings make them popular for architectural applications such as
sun shades and infill panels with the deeper cross bar serving as a
distinct architectural accent.